Category: "Mechanical Prep [grinding, polishing, vibratory finishing, buffing, honing]"

61692. Need Brush Finish on Steel Plates RFQ open to all: Washington - July 25

61675. Aluminum Panel is Mottled after sanding, buffing, waxing - May 27

  5396. Ra surface finish -- is it microinch or micrometer - May 16

29744. Is Abrasive Cleaning Needed for Proper Zinc-Nickel Plating Adhesion? - May 7

38491. Microfinish comparator finishes, visual roughness guide - April 25

  6053. Stainless steel vibratory finishing Q&A - March 1

14760. Repair brushed stainless finish open Q. - October 31

• Vibratory polishing of stainless steel components - May 15

• De-rusting/De-scaling of Heat Treated Parts open Q. - February 28

• Difference between Ra and Rc - surface roughness - January 26

• Mechanical finishing of body jewelry and wires open Q. - December 25

• Surface finishes N1 thru N12 and their equivalents in Ra - November 27

• Polishing chromoly chandelier - October 30

• Grinding HVOF coatings open Q. - August 14

• Formula for polishing and buffing compounds - July 16

• Very High Bond tape doesn't stick to mirror polished stainless steel - June 21

• Is there any Roughness Standard under N1 / Ra 0.025 ? open Q. - May 24

• What VDI Finish is required for light pipes? open Q. - May 12

• How to dull a stainless steel finish - May 9

• Need to do Deburring of Titanium RFQ San Luis Obispo CA - April 27

• Problems with stainless steel cut wire media in magnetic tumbler Thanks! Resolved :-) - April 13

• Superfinishing Stainless Steel - March 17

• Profilometer vs. surface comparator for castings - March 4

• How to clean steel contaminated with Sodium Metabisulfite. open Q. (February 5)