Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Adhesion quality concerns of Powder Coating over Zinc/Clear Chromate

Where can I go to find information on adhesion issues regarding powder coating of cold rolled steel that has been plated with a zinc/clear chromate finish?

Kathleen Bloomer
Sheet Metal Fabrication - Westbrook, Maine, USA
2004

Ed. note: This question is perennial here, Kathleen. letters 25173 and 3180 are a start, but if you use the search term "powder coating zinc chromate adhesion" in our search engine or "site:finishing.com powder coating zinc chromate adhesion" on Google you will find at least a dozen threads on this topic. Good luck.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: