Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Amateur chrome plating research information

To whom who can help:

I am a fishing amateur who cut and form my fishing spoon (from single one to the long chain of spoons for the lake trout with reflecting vinyl) starting from copper sheet of approximately 0.035 inch thick.

I am at the point to chrome plate my fishing spoon.

Where can I get the literature and equipment for such a project on an amateur basis?

My best regards,

Normand D
- Sherbrooke, Quebec, Canada
2001

We have an on-line Intro to Chrome Plating, available as text or audio. I think you'll find it helpful, Normand.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: