Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Decreased powder flow when coating lower racking arms

Q. We manually coat thousands of parts presented to the coaters on three tier racks. Powder flow is markedly less when coating parts on the bottom arms than it is when reaching for parts on the top arms. Hoses are short. Hoppers are adequate.

tom spear
pc mgr. - racine Wisconsin
April 8, 2017

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: