No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Chrome plating of plastics

September 4, 2009

Hi all,
I have one question related to chrome plating of plastics?
I want to know what are the precautions one need to take care while molding plastic parts which is going for chrome plating? One point I think is residual stresses that goes along with molding...What else?

I am a moldflow analyst and next week I'll be doing analysis of such project.

Thanks is advance..

Nitin Hadpe
India

Nitin Hadpe
analyst - Pune, India

Hi, Nitin. That is a good point, but there is more to it than that. If there is anyway possible, try to get access to the hard-to-find book "Standards and Guidelines for Electroplated Plastics". It has whole chapters on your subject.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
September 4, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: