Curated with aloha by
Ted Mooney, P.E. RET
The authoritative public forum
for Metal Finishing 1989-2025
-----
Seeking producer/processor for ceramic layer on circuit board
July 16, 2009
RFQ: to whom it may concern,
Hi, My name is Sunn, I have a urgent need for a producer or a processor on a specific ceramic coating/plating procedure.
We want a ceramic layer on our copper board about 17 x 3 x 0.3 cm. The requirements of the layer are:
1,primary criterion.very low conductivity --approximately tens of thousands.
2,thin--less than 0.5 mm.
3,smooth surface with no big holes.
If any company could do the job, feel free to contact me. I'm looking for a long term cooperation.
- Shanghai, China
Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).
(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)
Q, A, or Comment on THIS thread -or- Start a NEW Thread
Q, A, or Comment on THIS thread -or- Start a NEW Thread