Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Need buffing of a 23" dia. aluminum blanks 0.040 thk.

We need to buff to a mirror finish a 23-1/2" dia. 3003 alloy aluminum blank 0.040 thick. After sampling the production run would be 1,000 / 2,000 pieces.
I can supply a jig to hold the blank.
We used to use a Clair Buffing machine for this years ago.

Thanks
Gary B

Gary Bienvenue
reflector manufacturing - Fall River, Massachusetts
April 2, 2009

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: