Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

RELATIONSHIP BETWEEN Sa value and micron finish of surface

Is there any relationship between Sa values and Micron finish of surfaces after sand/shot blasting.
Also, let us know is there any measuring instrument available to measure such surface finish with conversion.

your reply shall be appreciated.

regards,
Joshi

Ratnakar D. Joshi
consultant to engineering industries - Mumbai, Maharashtra state, India
March 17, 2009

Hi, Ratnakar. I don't think any such conversion is possible. "Sa" is a Swedish Institute for Standards designation for blasted finishes -- approximately equivalent to SSPC, NACE, and ISO 8501 standards.

Please see thread 12526 for a more complete explanation.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
September 3, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: