Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Need Sn96.5%Ag3.5% plating on copper prototype and production metal stamping application

Our company needs a quote to plate a Tin/Silver Alloy on Copper as a selective plating process. The base metal is copper .012" thick and requires a .300" wide stripe on one side only on the material by coil for production and as chemically etched sheets for prototype. This is a definite project, we just need a certified plating vendor who is willing to provide this finish.

John W [last name deleted for privacy by Editor]
Metal stamping vendor - Rocklin, California USA
March 3, 2009

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: