No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2024

-----

Need chrome plating and polishing in Mexico

November 29, 2008

I have stamped steel parts, 1.6 dia. X 1.75 tall dome shaped parts, that need to be polished then chromed to yield a show quality finish for the motorcycle industry.

The stamping is done in Southern California, they would be shipped to Mexico to be copper plated then polished then nickel and finally chrome plated. The quantities would start at 2,000 and go up to 20,000 piece runs. This is just one of many parts I have to plate.

I have an Engineering company in Capistrano Beach, CA which designs and develops products for all industries in the souther California area, as well as the rest of the country, we are currently looking for suppliers in Mexico instead of using the suppliers in China.

John McGettrick
Engineering Consultant - Capistrano Beach, California, USA

Ed. note: Sorry, this RFQ is outdated, and contact info no longer available; but technical replies are welcome. No commercial suggestions please ( huh? why?)

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: