Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Lithium deposition

RFQ: I am working on a small research grant to evaluate the feasibility of creating a multifunctional material for structure and energy.

One energy source I am considering integrating into a structure is a lithium metal based energy cell.

I am looking for a source (job shop) that has experience depositing thin lithium films (1-4 micron)onto metal targets such as Ni or Cu. I would like to coat a couple of initial coupons and can supply the materials.

Roderick Rowland
MATSYS, Inc. - Springfield, Virginia, US
2000

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: