No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2024

-----

Need Cathodic Epoxy Electrocoat per MS-PB60-2

2006

I need wire-forms made from 1010 carbon material finished to the follow DaimlerChrysler specs.

Cathodic Epoxy electrocoat
MS-PB-2 per PS-7232 & PF-9968

Four (4) part numbers with an estimated annual volume of 430,000 each.

The wire products are used on exhaust systems. They weigh under one pound each.

We are located in Ft. Loramie, Ohio, and prefer a company within the neighboring states to keep transportation as low as possible.

Tom Raterman

Ed. note: Sorry, this RFQ is outdated, and contact info no longer available; but technical replies are welcome. No commercial suggestions please ( huh? why?)

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: