Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 317/44

Want NOMEX paneling in Fed Std 595 gray

RFQ: I am looking for Panel false deck gry NOMEX GRP sides 48" x 100 x .550" Thk W/ Co Bonded 3/16" 6 lb/cu ft x .003 thick foil 2-ply grp panel

This is FED STD 595 36270 NEMA Ty 2. Any help with locating this color paneling would be appreciated.

Rico Flores
installer - El Cajon, California, USA
2004
publicly reply to Rico Flores

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

A. Hi Rico. You might try to start with Dupont and ask them who is licensed to provide Nomex products like that. Your question is a bit off topic for this metal finishing site, but we have a lot of readers from the aerospace industry, so maybe someone can help. Good luck.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2004
publicly reply to Ted Mooney

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: