Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

ZINC BARREL PLATING OF TINY ITEMS--NEEDED IMMEDIATELY

2004

Help!

Have immediate plating job (will send anywhere).

Need: Capability for barrel plating Very Tiny items: Zinc with YELLOW chromate.

Item: 1/32" diameter X 3/8" long Cotter Pin, Steel, Plain.

Must avoid bending of parts...

Need to immediately plate process quantities: 25,000; 50,000; 100,000 pieces (don't have weights yet)

Any economic and good quality processor leads appreciated!

Jim D [surname deleted for privacy by Editor]
Fastener & hardware supply - Fort Worth, Texas

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: