Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Plastic part for consumer electronics needs selective chrome plating

2003

We have a small ABS plastic part about 1"x1.5"x.2" that we would like to Chrome plate (must be conductive, real metal) for RF reasons. However, certain areas must not be plated due to electrical and mechanical reasons.

25442

Liquid masking is too difficult to control, and part is too small to be double injected. Are there any processes that can give us this decorative and functional chrome plating?

Nai Yang
consumer electronics - San Gabriel, California, USA

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

There are all kinds of potential masking solutions, Nai. Not only liquids, but waxes, tape, and caps. A number of plating shops specialize in precision masking.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

finishing.com is possible thanks to our supporting advertisers, including:

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: