No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Need electrochemical modeling software

RFQ: I was after some information on modeling electrowinning cells, namely optimum current densities for particular tenor grades and cell volumes. A reference or any info would be appreciated.

Nigel Grigg
Australia
1999

Ed. note: Sorry, this RFQ is old & outdated, so contact info is no longer available. However, if you feel that something technical should be said in reply, please post it; no public commercial suggestions please ( huh? why?)

RFQ: I am looking for some information on modeling electrowinning cells, (wherein simultaneous deposition of metal at cathode and EMD at anode can be possible), namely optimum current densities for particular tenor grades and cell volumes, etc. A reference or any info would be appreciated

v misra
- New Delhi, India
1999

ElSyCa [Aurora, CO] and L-Chem [Beachwood, OH] are two suppliers of such modeling software that I know of. Please use google with the search term "Electrochemical Modeling". Good luck.
Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: