Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Seeking PTFE (Teflon) coating of aluminum strips and roll-forming into round bushings

PTFE (Teflon) coating of flat aluminum strips and roll-forming into round bushings with PTFE on ID and aluminum on OD. Various sizes, all are approximately 1.200 inches OD, .040 inches thick aluminum, .008 inches thick PTFE coating. ID of finished bushings is approximately 1.104 inches.

Brian Lang
- Roanoke, Virginia

Ed. note: This RFQ is outdated, but technical replies are welcome, and readers are encouraged to post their own RFQs. But no public commercial suggestions please ( huh? why?).

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: