No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

How to do Copper etching from drawing

Hello:

I am an Independent Information Professional and a client has been asked to provide a drawing of a colleague which will be made into an etched copper plaque for wall display.

In order to carry this out, he needs to know the criteria to observe so that the etching process will be successful.

For example, how fine can the lines be to create tone assuming it is photoetched? Which drawing techniques are most effective, e.g. hatching, dots, etc.

Thank you.

Peter Hall
- Vancouver, BC, Canada
2001

Zacryl has info on the process, probably best to find a artist - printmaker to do it for you.

James Scanlan
- St Helena, California, USA
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: