Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

MIL-A-8625 Type I, II, III Spec.

Dear Sir,

Is it possible to send a full set MIL-A-8625 / MIL-PRF-8625 [on DLA] Type I, II & III specification to us for study.

Regards,

S. Ng
- Hong Kong
2001

Go to astimage.daps.dla.mil/quicksearch/ and type in "Mil-A-8625" in the document ID box.

Good luck!

Lee Gearhart
metallurgist - E. Aurora, New York
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: