Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Installation / type of piping required

Does DI water require stainless steel piping (for example to a steamer) or is copper piping OK?

Mark Lipke
AVTEC Industries Inc. - Oswego, Illinois, USA
2001

316 Stainless steel is a good choice for DI water. If cost is an issue, CPVC pipe is an excellent choice and is much less. Be careful though to make sure of your pressure and ambient temperatures are not excessive. Copper would not be preferred choice.

Mike Loy
- Stockbridge, Georgia, USA
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: