Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

E-Coat Standards?

Q. I am looking for an industry standard for e-coating A380 die castings. The finish material is PPG Powercron AR330. Any details would be appreciated.

Kevin Yuskis
- Richmond, Virginia, USA
2001

Q. What is the expected loss (part loss in tank) for e-coating a part 12" x 12" x .250 thick approx. 9.5# during standard e-coating process?
Thanks

David Duchesne
metal fabricating - Indianapolis, Indiana, USA
February 22, 2013

A. Hi David. I'm probably misunderstanding the question, but I think the answer is zero.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
February 25, 2013

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: