Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Abrasion properties of polyester fibres

I am currently investigating the abrasiveness of polyester yarn coloured with dye formulations containing a variety of inorganic pigments including cobalt, barium sulphate, zinc sulfide, titanium dioxide and carbon black. Does anyone have any suggestions regarding this.

Nawahl Gieriden
- Cape Town, South Africa
2001

Hi,

Probably the most knowledgeable people on this matter is the DuPont technical staff. But I would suggest that if your main interest is the wear of parts in contact with the fibre you should go to the people of Surface Technology, Inc., the company with the best technology to fight against it.

Good luck

Guillermo Marrufo
Monterrey, NL, Mexico
2001

Hai Nawahl Gieriden,

Abrasion properties of polyester yarns is a very complex phenomenon involving surface structure and related aspects. You try to study the surface structure by electron microscopy just after yarn formation. Then you study the roughness properties of the abradant, before going for abrasion characteristics.anything? Reply.

Senthil Kumar
- Tamil Nadu, India
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: