No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Electropolishing of 316L Stainless Steel

I need any available information on electropolishing and setting up an electropolishing facility for Stainless Steel 316L. The goods to polish are very small and delicate (less than 0.1mm wall thickness). Who specialises in consulting?

Markus Lehmann
- Cape Town, South Africa
2001

Attention Markus Lehmann,

If you can contact me and let me know the size and volume of components to be treated, finish required etc. Whether you want to purchase capital equipment to do the job yourself or contract the job out and I can advise the best options for you that I can think of.

Regards,

Bryan M [last name deleted for privacy by Editor]
- Perth, Australia
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: