No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Mils Specs in Australia

I am having trouble obtaining mil specs in Australia. Are they on the Web?

Chris Sweetnam
- Australia
2001

Yes, I asked the same question recently and I was pointed in the direction of ASSIST ~~assist.daps.mil~~, I did find it a bit troublesome to use, but eventually I was able to get the specs. that I wanted.

Good luck

David Grimes
plating company - Farnham, Surrey, United Kingdom
2001

----
Ed. note 5/29/12: That mil specs page has moved around several times over the years, but is currently at assist.daps.dla.mil/quicksearch/
Ed. note May 2013: make that quicksearch.dla.mil

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: