Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Looking for Metal Samples

Looking for metal samples for a collection similar to a rock collectors hobby, only metal. Rare or exotic alloys, stainless and titanium to begin with.

Joseph Bodden
- Covelo, California, USA
2001

2001

Hello Joe!

If you don't mind samples that have been etched, I can probably get you some. As part of our routine receiving inspection, we test samples of most of our incoming bar stock. I'd probably want you to pick up the postage. Drop me a note at , and we'll take it from there.

Lee Gearhart
metallurgist - E. Aurora, New York

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: