Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

ANODIZE

I'm having some problems with the finish on parts currently being anodized. The material is Precision Cast Tool and Jig (MIC-6). The question: Is it possible to get different colors of clear anodized parts from the same piece of material? I'm talking about night and day between the parts.

Joe Roberts
- The Woodlands, Texas
2001

I can answer your question with just one word....YES

Marc Green
anodizer - Boise, Idaho
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: