Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Etching Stainless Steel Mesh

I am looking for a suitable stainless steel etching/brightening solution to allow etching of a fine stainless steel mesh thereby reducing the wire diameter on the mesh. I have a paper from the Review of Scientific Instruments (November 93, page 3094) which mentions a solution "DS9", but I have been unable to contact the author or track down DS9.

Can anyone recommend a product, or a recipe. (I have access to fume cabinets etc for safe handling).

Ed Roberts
Australian National University - Canberra, ACT, Australia
2001

DS9 Henkel Technologies Deoxidine 314 pre mixed solution.

Good luck

Grant Crawford
Aerospace - Kitchener, Ont, Canada
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: