Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Conversion of Surface Finish

Equation for converting metric to standard or vise-versa, or a chart of conversions. Maybe a web site to where I can get this info--thanks.

K. Hansen
- Austin, Texas
2001

Mr Hansen

I think www.camper.netsurf.it provides the information you need.

Regards

Francesco Cicchetti
- Sulmona, Italy
2001

Sir,

You may access www.pfonline.com~~/tools/conv_fact.cfm?zn=powder~~ to click the conversion table for your information.

Subramanian Ramajayam
consultant - Bangalore, India
2001

----
Ed. note 11/27/06: That particular page is apparently no longer functional, although the site is.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: