Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

How to fix/weld this lamp metal

Q. I had a piece of sheet rock fall on my hall lamp. Absolutely no markings on the lamp as far who/where it was made. House built in 1991. Trying to figure out if I can repair the cracked base.

61660-1b 61660-1c 61660-1d 61660-1a

Not sure what material it is made of.
Thank you,

Jeff Miller
- Davis, California
April 17, 2024

J B Welds

jb weld

on eBay or

Amazon

(affil links)

A. Hi Jeff,
It appears to be a diecasting. It could be zinc, aluminum, or a zinc-aluminum alloy, but in this case it probably doesn't matter.

I think the way to fix it is with reinforced epoxy. It has always amazed me how good J B Weld ⇨
is at such stuff. But if you've got the funds and the interest, I've heard that Muggy Weld ⇦this on Amazon [affil link] is excellent (although I have no personal experience with it).
Luck & Regards,

ted_yosem
Ted Mooney, P.E. RET
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

Thank you Ted, greatly appreciated.

Jeff Miller [returning]
- Davis
April 20, 2024

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: