Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

What is spec P56011 and P55004?

Q. We are having trouble tracking down a couple of specs. If anyone could help send us in the right direction it would be greatly appreciated. The specs are P56011 and P55004.

Tyler Barnhart
- Chanute, Kansas
October 23, 2020

A. Hi Tyler. Large companies like GE and GM used to each have thousands of specifications. So any hints at all, like whose drawing it was on, whether it's for electroplating or some other finishing process, or anything at all as a starting point would help. I don't know if we'll be lucky enough to attract a reader who knows those two particular specs.

Luck & Regards,

Ted Mooney, P.E. RET
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
October 2020

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: