Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

What Ra or Rz Needed before Bright Plating?

Q. Hello I have a question: for metal plating processes such as nickel, what should be our surface roughness for a bright surface? is there any knowledge about this stuff? And which data we should we care about, I mean Ra, Rz, Rq ... ?
Thank you.

yunus sezgin
- istanbul TURKEY
October 9, 2018

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: