Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 603/40

How to gold plate rough stone surface

Q. Hello sir.

I am trying to make a natural stone pendant, but natural stone slices have irregular surfaces and it is very difficult to do gold or silver edging.
Is it possible to use any inexpensive metal powder for fixing on edges before gold edging?
Please advice me if you have any solutions.
I hope you help me.

Thank you

Jhulaha J [surname deleted for privacy by Editor]
student - India
December 15, 2016
publicly reply to Jhulaha J

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: