Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Mixing of polyester and polyesterimide in magnet wire production

Q. Dear sir, please reply for my question. We are a magnet wire manufacturer near new Delhi, India. We are producing copper 9.15 * 3.21 mm strip. We are using polyester in first 8 passes and polyesterimide in last 4 passes. Temperature of first zone and second zone is 280 °C and 340 °C. We are using catalyst machine. Before catalyst temperature and after catalyst temperature is 460°C and 450°C

Ravish Pandey
engineer in magnet wire industry - sonipat, haryana, India
May 9, 2016

May 2016

? Hi Ravish. I am not familiar with magnet wire production, but hopefully another reader will be. But are you sure that you remembered to ask your question?

Regards,

Ted Mooney, P.E. RET
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: