Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Properties of Zinc vs. Manganese Phosphated Fasteners

I am a metallurgical engineer work for a multinational engineering industry. I would like to know if there is any difference in the tribological properties of Zn-phosphated & Mn-phosphated fasteners? Is there any difference in fatigue properties?

Sachin S Ghanpathi
- India-Pune
2000

Manganese phosphate is used as a final finish plus oiling while zinc phosphate is mostly used as base to paint.

Sara Michaeli
Tel-Aviv-Yafo, Israel
2000

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: