No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Nickel as an aluminum anodizing contaminant

Q. It was just brought to my attention that for some reason we recently penetrant inspected some parts that had been nickel plated. Since they were penetrant inspected, we had to etch them, which I don't think did aything to them but the ensuing Nitric acid deox probably did. After deoxidation, they were then Sulfuric Acid anodized. My question is, Is there any possibility of this small amount of Ni in the Anodize hurting the process?

Scott Merritt
Chemist - Eastman, Georgia, United States
June 11, 2012

A. NO.

Robert H Probert
Robert H Probert Technical Services

Garner, North Carolina

June 13, 2012

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: