Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 585/35

How to Braze Aluzinc to Aluzinc

Q. I have a sample which has brazing to attach two aluzinc materials; the base part has 15mm hole and is brazed to child parts inside that 15mm hole. The thickness of the material is 1.5 mm
it looks to be done in a special machine.

58535-1 58535-2

Mohammed Adil
- Bangalore, Karnataka, India
May 14, 2012
publicly reply to Mohammed Adil

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: