Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Best way to blacken newly etched framing squares

February 21, 2012

Q. We have come to market with a new framing square and I would like to continue to look for the best possible way to blacken the etched increments and tables on the square that will be the most durable and look the nicest? Suggestions on a finish (not a coating) for the 304 SS (to reduce glare, etc.) would be appreciated as well.

Tait Chappell
Vice President - Brownfield, Maine, USA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: