No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Looking for plater to handle computer chassis parts

RFQ: We are looking for a plater able to provide a finish similar to commercial computer chassis. Finish should not show finger prints, or at a minimum any prints left should wipe off with no use of chemicals (alcohol, etc.). Plating to be done over CR Steel. Color should be silver. Prefer plater in the North-East USA.

Pete Cardona
- Hollywood, Maryland, USA
December 14, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: