No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Cleaning acrylic for better electroless deposition

Looking for recommendations on good cleaning agents and/or techniques for cleaning Acrylic plastic before performing electroless deposition. I keep getting these clear spots where there is no deposition seems like there is still some oils or something keeping the solution from contacting my acrylic. In other areas the adhesion is not very good. I believe this is all related to bad cleaning techniques or the poor wetting characteristics of Acrylic. Any suggestions?

Colin Gibson
Hobbyist - Rolla, Missouri, USA
December 7, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: