No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Cylindrical grinding down to mirror finish

Hello

I have 5 stages Cylindrical grinding machine (belt abrasives) and I'd like to grind stainless steel tubes down to Ra<0.1 µm and Rsm >100 µm (mean spacing).
The starting roughness is about Ra=0.5 um

I'll appreciate to know the governing principles of driving down Ra while keeping the groove spacing high
Thanks
Doron

Doron Nakar
- Israel
December 3, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: