No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Suggestion Required - Stainless Steel Electropolish

December 1, 2011

Am Jagadeesan from India (Chennai). We have small stainless steel utensil making Industry. We are currently doing buffing and polish through manual polishing motors. I am planning to have a Electropolish method. Can you suggest, what type will be better for this enclosed attachment. Thickness of this will be less than 0.45 mm and Nickel % will be less than 1%.

Thanks in advance.

Regards,
Jagadeesan S

Jagadeesan Sankaran
- Chennai, Tamilnadu, India

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: