No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

My First Project

This is my first project, an old 38 special that works great but looking very well used. This sounds like just what the Doctor ordered to restore! But first I just wanted to know if I needed to sand or remove what's left of the original Rusty Pitted finish on the gun parts to bare steel before the rusting process? or just start with the way it is? Any advice would be great!

57978-1 57978-2 57978-3

Stephen Cacciola
Hobbyist, Reloader, Collector - Phoenix, Arizona, USA
November 11, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: