Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

White spots and black crusts in Electropolishing

Sometimes doing electropolish on SS 304 powder metallurgy part, I see some white spots; they are whiter than the area surrounding them, my question is where they come from.

Also I see some black crust on the part surface difficult to remove, which is the best method to remove it?

Daniel Hernandez
Plating shop - Bucaramanga Santander Colombia
October 19, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: