Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 575/66

The future of the Powder coating business

Dear All,

this is Mr. Vikas Patil from Pune, INDIA.

I am going to start my powder coating business in Pune itself.

I have knowledge about it & have done SWOT analysis (Strengths, Weaknesses, Opportunities, and Threats) too; still I want to know much about scope for this business in future?

Thanks & Regards,

Vikas Patil
Powder Coating Shop - Pune, Maharashtra, India
August 13, 2011
publicly reply to Vikas Patil

August 22, 2011

HOW HIGH IS THE SUN?
The threats are with the treatment of Aluminium & Chromate.
The opportunities are with thermoplastics and site spray.
The difficulties are with adequate preparation for site spray.
Hope this helps,
Regards,
Bill

William Doherty
Trainer - Salamander Bay, Australia
publicly reply to William Doherty

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: