Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Zinc vs. black oxide, which is heat resistant if at all

Zinc vs. black oxide? Need to know which coating is more heat resistant and less likely to break under heat application of around 600 F to 800 F in an exhaust manifold.

57044 57044-2

Melissa Arrington
parts and engine upfitter - McKinney, Texas, USA
April 14, 2011

Zinc's melting point is a little under 800° F

Trent Kaufman
electroplater - Galva, Illinois
April 19, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: