Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Aluminum alloy/bagasse ash piston finishing

Good afternoon Sr/Ma, I'm Ebelebe Gideon an MSc student in Nigeria, my MSc project is on construction of an Aluminum alloy/bagasse ash particulate piston, please what are the steps involved in the finishing operation[s]. I would like if you can send response.
God bless your children. Amen.

Gideon Ebelebe
Ahmadu Bello University, Zaria, Nigeria. - Zaria, Kaduna State, Nigeria
March 8, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: