Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Seeking electropolishing

I am building a luggage rack for a motorcycle from scrap stainless. Have been trying to buff n polish the bar stock and angle before welding it . now I am reading about electropolishing and this sounds like this may be the way to go. Where can I get this done here in New England ? thanks in advance. Matthew

Matthew Hawk
- Cumberland Rhode Island USA
February 26, 2011

Hello any and all ,

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: