Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 568/10

Warping problem in tungsten carbide coating

Dear Sir,

we are facing issue in coating Tungsten carbide "DURMAT 101" over the hardox 400 plate. The hardox plates get bent while we try to do the carbide coating. Do you have any SOLUTION.

VIVEK R
Engineer - Chennai, Tamil Nadu, India
February 23, 2011
publicly reply to VIVEK R

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: