Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Building gold bug recovery system

hi.I want know how I can make a gold bug recovery system?:D

Mostafa Sarparast
student - Iran
January 18, 2011

Hi, Mostafa. You can build an electrolytic recovery cell, but you can't build a Gold Bug because that is a trade name for one particular brand, and its trade-secret design is the result of 25 years of development. But in general, an electrolytic recovery cell is just a plating tank that has been optimized to plate at relatively high efficiency despite a low concentration of gold.

Some of the keys to that are very high surface area cathode, close anode to cathode spacing, and very high agitation or recirculation rate. Practical considerations include careful design against short circuits, good electrical fusing, and guarding against spontaneous combustion due to the metallic fines. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
January 19, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: