No passwords, No popups, No AI, No cost:
we earn from your affiliate purchases

Home /
T.O.C. Fun
FAQs Good
Books Ref.
Libr. Adver-
tise Help
Wanted Current
Q&A's Site 🔍
Search

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Stripping satin nickel and nickel chrome from zinc die casting

December 7, 2010

Hello,

Can anyone help to give me any formula or guide to do the stripping of satin nickel and nickel chrome from zinc die cast parts?

Currently we're using solution sodium cyanide and strip 210. After stripping, the parts came out with damaged surface..Anyone? pls help me..

Mike Fuzz
chemical engineer - Malaysia

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops Capital
Equipment Chemicals &
Consumables Consult'g,
& Software